Claw Machine will not close

General forum for claw addicts to discuss this crazy hobby!
Forum rules
If you are under 18 years of age, please DO NOT use your real name. Any flaming or disrespectful behavior will not be tolerated. You will be given a warning. Once. Otherwise, enjoy the forum :)
Post Reply
brennan121212
Posts: 1
Joined: Thu Sep 17, 2015 12:22 am

Thu Sep 17, 2015 12:27 am

So I recently bought a smart industries 5th generation clean sweep crane machine. Nothing was working except the lights. I replaced the power supply and switched out the fuses and now everything works except that the claw won't close. When I first put in the new power supply it would snap shut and it did that for a few times when I'd boot it up. Now I can't get it to close at all. I've checked all the connections and can't get any voltage out of the two wires leading up to the claw solenoid. Any suggestions would be great! Thanks!

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests